The frame layout table

So the layout has begun, Because the body is not standard neither is the frame, and it requires a special custom frame where nothing is at a 90 degree angle.  Even the rear end which appears to be 90 degrees has a small angle between the rear cross member and the side rails.  
A second angle brings the side rails closer together from the front door frame to the front cowl edge.  From there forward a small angle back outward will keep the side rails the appropriate distance apart for the late 30s grill shell.  More to follow so stay tuned! 



 

Comments

Post a Comment

Popular posts from this blog

Cheap work area expansion or the Taj Ma Tarp!

Image
  Currently Gray Goats Rod and Custom works out of a modest 30 x 40 two car shop located on a piece of country property.  But this was not always the case.  The early years of the C buckets development took place in a VERY cramped single car garage.  The driveway was available on rain free days, but the southern sun can be brutal and I had to find an inexpensive solution.  Thus the Taj Ma Tarp was born.  A trip to Harbor Freight for a 12 x 12 tarp (I think it was 12x12 its been a while as I type this) with a stop at Home Depot for s couple lengths of electric conduit, a little rope and I was in business. Inside the garage door some screw in hooks I had laying around were screwed into the beam over the door to catch the grommets in the tarps edge.    Three equal length sections of conduit were cut and the ends compressed in a vice around a 16d nail with the head exposed.  This point is to go through the grommets on the corners of the tarp. Two...
Read more

Rear diagonals

Image
I included this one just for fun, below are the main accomplishments for the day, rear diagonal braces. Oh and I set the body in place just for fun This was more challenging than it appears at first since the side rails are not at 90 degrees.  The bottom angle is 45 degrees, but the sides are not.  I just marked it and cut it close, then ground it to fit before tacking it in place.
Read more

Found treasure in Savanah

Image
So my wife and I went on a long weekend to celebrate our anniversary and while cruising antique stores found this wheel.  I wanted something different/unique/cool for the C bucket and ran across this vintage boat wheel.   No idea yet what it was from, and I know I'll need to make an adaptor but the center is steel and the rim is mahogany.  Another project in the progress but it will be different :)  
Read more