Grafting in a 1927 Chevrolet firewall

 

This is the final product, a 27 Chevrolet firewall blended into the modified body.  This is how it got there...

I started with the smoothed firewall on the modified body and puzzled for quite a while about how to add the Chevrolet style firewall I wanted.  Eventually I decided to mold in an original 27/28 firewall that I bought out of the mid-west.


It started out with a good bit of surface rust and quite a few holes but once patched

filled

primed and sanded

it was ready to install.  I cut out a section of the cowl and grafted in the newly restored piece

and after a good bit of finish work...












 

Comments

Post a Comment

Popular posts from this blog

Frame horns!

Image
 So yesterday The front cross member found it's home, today I refilled the old gas bottles and bent and trimmed the frame rails around the cross member.  Double checking after all this heating and beating revealed that the frame was still square, measuring 114" from corner to corner.  A quick check with a digital level revealed the top edge of the frame is still dead level in every direction. This is how the day started  
Read more

Why I changed a 1923 T into a 1927 C bucket roadster

  Ok so this post is a bit out of order but like I said on the opening page it is different from your average blog in that things posted have already happened so the order of posting is a bit flexible. I have been asked to detail more clearly where I deviated from the original Chevrolet design and why.       I made some changes for aesthetics and some for more practical reasons.   My basic theory comes from examining the cars I really like and trying to figure out why I found them so appealing.   Watching an interview with Chip Foose one day he condensed his design theory into a simple form even I could understand.   Basically it consists of looking at the overall design and taking away any ugly or distracting parts while improving the overall flow of the vehicle.   Anything that stands out as out of place or disturbs the flow of the lines should be fixed.   Details should appear only on close examination but should disappear when you ...
Read more

Cheap work area expansion or the Taj Ma Tarp!

Image
  Currently Gray Goats Rod and Custom works out of a modest 30 x 40 two car shop located on a piece of country property.  But this was not always the case.  The early years of the C buckets development took place in a VERY cramped single car garage.  The driveway was available on rain free days, but the southern sun can be brutal and I had to find an inexpensive solution.  Thus the Taj Ma Tarp was born.  A trip to Harbor Freight for a 12 x 12 tarp (I think it was 12x12 its been a while as I type this) with a stop at Home Depot for s couple lengths of electric conduit, a little rope and I was in business. Inside the garage door some screw in hooks I had laying around were screwed into the beam over the door to catch the grommets in the tarps edge.    Three equal length sections of conduit were cut and the ends compressed in a vice around a 16d nail with the head exposed.  This point is to go through the grommets on the corners of the tarp. Two...
Read more